XpressFill Volume Filler (Adj Shelf) - 4 Spout

Cowboy Craft LLC

WE654

アメリカ国内の送料、日本までの輸送費はご購入品の点数、為替によって大きくことなるため表示価格は商品代金のみとなります。

この商品のご購入までの流れ

  1. お客様による機種の選定、商品代金の決済
  2. 入金確認後、商品手配開始、日本までの輸送費を算出
  3. 最終確定金額の請求書をお客様にご送付
  4. お客様による最終確定金額の決済
  5. 入金確認後、アメリカより商品出荷

納期

商品の在庫状況によって異なるため、お気軽にお問合せ下さい。

商品詳細

Help eliminate oxidation in your bottling process by using XpressFill volume-based filling system. Gravity-based systems usually involve wine being transferred to a holding tank, and unless the your bottles and holding tank are pre-flushed with inert gas, some degree of oxidation is inevitable. Xpresfill bottling systems have a closed pathway with a self-priming pump. They also have as an optional built-in sparging (pre-flushing) system that uses Nitrogen or Argon to pre-flush your bottles.

To use, place four bottles under the filling spouts, push the gas button (optional at additional cost) to flush the bottles with inert gas. Then hit the Fill button which pulls the wine from your barrel or stainless storage tank, distributes 750ml of wine to each bottle, and shuts off automatically when done. It is truly that simple. Each fill cycle lasts 20 seconds. Realistically with bottle movement (and talking and drinking!) expect to fill about 200 bottles per hour with the 2 spout and 400 bottles per hour with the 4 spout.
There is also a manual mode allowing you to top up bottles or fill odd size bottles (connect tubing and fill magnums for example.) You my have seen this system for sale before as the Vigneron. Xpressfill purchased Vigneron and redesigned the unit to be driven by a digital controller. The result is a unit that works much better. MoreWine! has tested the unit and we are happy with the performance.

The XpressFill is a volume based system that fills each bottle with a set volume of wine (usually 750ml per bottle.) The fill is accurate to within +/- 1.5ml. However, bottles themselves can vary in volume by a couple percent and when you are filling by volume this can result in different fill heights, especially if you fill into the bottle neck, where differences are exaggerated by the small diameter of the neck. Fill heights will therefore vary from bottle to bottle but differences are usually 1/2" or less.

Further protect your wine from oxidation when using an XPressFill by adding the Gas Flush option to your filler. Push the gas flush button for as long as you like prior to each fill cycle. Inert gas will be forced into the bottle displacing most air, greatly reducing oxidation during the bottling process. You will need to supply an Argon or Nitrogen tank, regulator, and section of 1/4 " tubing to connect an inert gas source to the machine.

※日本では、アルコール度数1%以上の酒類を酒類製造免許なしに製造することは、酒税法により禁じられています。酒類製造免許を持たない方は、アルコール度数1%未満となるよう調整して下さい。


コレクション: ボトリング関係, ボトリング関連, 瓶詰・フィラー

カテゴリー: Bottling Supplies

商品タイプ: 瓶詰・フィラー


関連した商品